Evolve-communications RD5000 Manuel d'utilisateur télécharger pdf (Page 11)

*Trademark

Note If you have more than one serial port, make sure that the RemoteLinker*

software is configured to the one that you’re using. To access COM port

settings, right-click on the RemoteLinker icon located in the lower right

hand corner of your computer screen. Choose Settings. Select the correct

COM port to which you will be connecting the cable and click Apply.

Connect RemoteLinker* Cable

Before you connect the RemoteLinker* cable, you should determine the COM

port to which you will be attaching the cable. If your computer is on, perform the

shutdown procedure recommended by the manufacturer and turn it off. Turn your

computer back on after connecting the cable as indicated below.

Getting Started

Connect the small end of the cable to

the bottom of your GUIDE Remote.

Connect the large end of the cable

to the PC serial port.

Activate Remote Control

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Pas de commentaire

Evolve-communications RD5000 Manuel d'utilisateur Page 11